22
Washing Clothes
Before washing clothes for the first time, the washing machine must be run with a small amount of
detergent and without clothes. Follow below instructions.
1. Connect power source and water.
2. Place a small amount of detergent into the detergent dispenser
and close.
3. Press the [Power] button
4. Press the [Start/Pause] button
I. Pre-detergent or washing powder
II. Main Detergent
III.* Softener
Once you have loaded the washer and added laundry products, you are ready to wash and dry.
Start the Washing Machine
1. Make sure the unit is connect to a power source and water lines are properly connected.
• Tap should be opened completely
• Place your wash load into the drum.
2. Press the [Power] button. Control panel will illuminate.
3. Turn the cycle selector knob to the desired cycle based on load. The LED display panel will
reflect the preset features for that cycle.
4. If you would like to modify any of the preset settings for the desired cycle, press on the individual
options until the display panel reflects the desired settings.
Note: If you have a favorite cycle, once you modify all settings, press and hold [Custom
Cycle] to save for future cycles. Depending on the desired cycle, all options may not be
available.
5. Press the [Start/Pause] button to begin cycle. Once the cycle begins, the door will automatically
lock and wash cycle will begin. Display panel will change to reflect estimated time and state of
wash. At any time, you can pause the cycle by pressing on the [Start/Pause] button again.
Detergent Dispenser Drawer:
To Next Page
Loading...
Need help?
General
