To Next Page

To Previous Page

CONTROL PANEL

OPERATION INSTRUCTIONS

Figure 6

a b c f d e

a. POWER: Turn the power on by pressing the “Power” button. The unit will beep and the light above the

button will come on, indicating power is being supplied to the dryer. The default settings (Extra Dry and

Medium) will be selected. Press the button again to turn the power off.

b. DEWRINKLE: Press this button to add the Dewrinkle program to any dry cycle. This program will add a 20

minute air-dry cycle after the selected drying program. During this program, only cool air will be generated

to help prevent creasing of the items that were just dried.

NOTE: DO NOT overload the dryer. Remove the dried items from the dryer immediately and hang up or fold them.

c. PROGRAM: Press this button, repeatedly, until the desired drying program is selected. The respective light

beside the program will illuminate, indicating which program is selected. The drying times also include a 10

minute cooling function.

• EXTRA DRY: Sensor Dry – The unit will run until the humidity level in the drum has reached ≤35%.

Then the unit will stop heating and go through 10 min. of air cooling to end the program.

• NORMAL DRY: Sensor Dry – The unit will run until the humidity level in the drum has reached ≤40%.

Then the unit will stop heating and go through 10 min. of air cooling to end the program.

• LESS DRY: Sensor Dry – The unit will run until the humidity level in the drum has reached ≤45%. Then

the unit will stop heating and go through 10 min. of air cooling to end the program.

• 1 HOUR DRY: The unit runs for a set time of 60 minutes – 50 min. on full power heating and 10 min. of

air cooling. PLEASE NOTE: For this Program, Temperature Selection is disabled.

d. TEMPERATURE: Press this button, repeatedly, until the desired heat setting is selected. The respective light

next to the heat setting will illuminate, indicating which program is selected.

• High: Dryer uses two sets of heating elements running simultaneously, providing the strongest hot air flow.

• Medium: Dryer uses two sets of heating elements for 10 minutes, and then uses one set of elements

for another 10 minutes, alternating back and forth.

• Low: Dryer uses one set of heating elements, providing the weakest hot air flow.

e. START/PAUSE: Press the button to start the set drying program. The light above the button will illuminate,

indicating that the dryer has started running. To pause a drying program, press the “Start/Pause” button. If

Magic Chef MCSDRY35W User Manual

Questions and Answers: