To Next Page

To Previous Page

INSTALLATION INSTRUCTIONS

LOCATION

1. Examine the dryer after unpacking. Check for damage such as a misaligned door, broken door or dent in the

cavity. If any damage is visible, DO NOT install, and notify your dealer immediately.

2. Check to ensure that you have the wall-mounting kit and four (4) legs.

3. Install the dryer on a flat, level surface. If you are going to wall mount your dryer, use the included wall-

mounting kit.

4. Install the dryer away from direct sunlight; direct sunlight may affect the acrylic coating, plastic and

electrical components. The room temperature should not fall below 32°F.

5. Check the ventilation. DO NOT block the air vents, especially when the dryer is installed on a carpeted

floor. If the air vents are blocked during operation, the dryer may overheat and eventually fail. For proper

ventilation, allow at least 5 inches of space between the dryer top, sides, rear, and adjacent surfaces.

6. Install the dryer away from heating appliances and water taps. Keep the dryer away from heat, steam, or

splashing liquids. NEVER splash water onto the control panel. These things can adversely affect the wiring

and electrical conduction contacts of the dryer.

7. Check the power supply.

a) Check your local power source. The dryer requires a current of approximately 12 Amperes, 110 Volts,

and a 60 Hz grounded outlet.

b) A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or

tripping over a longer cord. Ensure that the dryer does not stand on its power cord.

c) Use of an extension cord is not recommended. If an extension cord is used:

• The marked electrical rating of the cord set or extension cord should be at the very least equal

to the electrical rating of the appliance.

• The extension cord must be a grounding type, 3-wire cord.

• A longer cord should be arranged so that it will not drape over the appliance where it can be

pulled on by children or tripped over unintentionally.

d) Plug the dryer into a properly installed receptacle box that is fully grounded. DO NOT under any

circumstances modify, cut or remove the third (ground) prong from the power cord. Any questions

concerning power and/or grounding should be directed toward a certified electrician or an

authorized service center.

INSTALLING THE LEGS

The dryer is shipped with a bag containing

the user guide and four (4) legs. It is

recommended to screw the legs all the

way in. See the illustration to the right to

install the legs.

Bottom

of Dryer

Figure 5

Leg

Magic Chef MCSDRY35W User Manual

Questions and Answers: