EasyManua.ls Logo

Magic Frontier V6 - 5.5 Seat Tilt Option Operation

Magic Frontier V6
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 17
Freewheel Levers, UP ENGAGED, DOWN = DISENGAGED
The wheelchair controls will not function and a message will appear on the screen “brake error”
when the chair is in free-wheel mode. This feature has been intentionally incorporated to protect the
user from unsafe situations. These levers are intended for use by the attendant.
Push the levers back up again firmly after manually positioning the chair. Turn the power off and on
again to remove the error message.
WARNING! Do not use your chair in freewheel mode or attempt to place your chair
into freewheel mode without an attendant present. You may cause injury to yourself
and to others. Do not place your power chair in freewheel mode while on an incline.
The chair could roll uncontrollably on its own, leading to injury to yourself and
others.
WARNING! When the power wheelchair is in freewheel mode, the braking system
is disengaged.
5.4 Electrical Safety Protection
Your wheelchair has a fuse fitted into the battery circuit to protect the motors and electronics from
an accidental current overload. In the case of a blown fuse, the chair will not drive and you will need
to contact your Magic Mobility dealer for repair / replacement
5.5 Seat Tilt Option if fitted
To operate the seat tilt:
Bring your power chair to a complete stop on a flat level surface.
Always fasten the positioning belt when operating the seat tilt option.
Push the ‘Mode”button on the joystick. Select seat tilt by moving the joystick left or right. Once
the seat tilt option is highlighted, moving the joystick forward or backwards will operate the
function.
Once the seat reaches its highest tilt angle, the tilt action stops; release the joystick at this point.
Before driving, return the seat to its upright position. When returning to the upright position,
always be sure that the mechanism has reached its lowest limit or normal seated position.
WARNING! Never tilt the seat from its upright position on an inclined surface or on
bumpy or uneven surfaces. Never raise the seat tilt while your power chair is in
freewheel mode. Failure to heed this warning can result in the power chair tipping
over and causing personal injury.

Table of Contents