EasyManua.ls Logo

Magic Frontier V6 - 6.10 Daily Joystick Checks; 6.11 Weekly System Checks

Magic Frontier V6
46 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 23
6.8 Basic Programming and set-up
Basic programming can be achieved by pushing and holding the decrease/increase speed buttons at
the same time
This will take you to a menu so the screen brightness, clock and trip distance can be set and re-set.
6.9 LCD Screen
The status of the control system can be understood by observing the LCD screen. The control
system is on when the screen is backlit.
Care
Avoid knocking your control system, especially the joystick.
When transporting your wheelchair ensure the control system is well protected.
To prolong the life of the control system, keep exposure to extreme conditions to a minimum.
Always clean your control system if it becomes contaminated with food or drink.
Use a damp cloth and washing up liquid mixed with water. Do not use abrasive or spirit based
cleaning agents.
6.10 Daily Checks
Joystick: With the control system switched off, check that the joystick is not bent or damaged
and that it returns to center when you release it. If there is a problem do not use your
wheelchair and contact your service agent.
6.11 Weekly Checks
Electrical Brakes: This test should be carried out on a level floor with at least one meter clear space
around the wheelchair.
Switch on the control system.
Check that after 1 second the battery gauge remains on or flashes slowly.
Push the joystick slowly forwards until you hear the electrical brakes operate. The
chair may start to move.
Immediately release the joystick, you must be able to hear each electrical brake
operate within a few seconds.
Repeat the test three times, pushing the joystick backwards, left and right
respectively.
If your wheelchair is fitted with lights, turn indicators or seat adjustment actuator,
checks the operation of these.
Connectors: Check all connectors are secure, properly mated and free from damage.
Cables: Check condition of all cables for damage.
Joystick Gaiter: Check the thin rubber gaiter around the base of the joystick for damage or splitting.
Check visually only, do not handle the gaiter.

Table of Contents