List of Error Codes
Error Code Error Display Message Action
05000050 Failure occurred during card loading.
Check to ensure that the laminator is properly
connected to the card printer. (
A
Page 11 “Card
Printer Connection”)
Remove the card. (
A
Page 32 “Card Jam”)
●
●
05000051 Card jam near the card feed roller.
The temperature of the heating roller may be too
high, or the card transfer speed may be too slow.
For details on adjusting optimum settings, please
consult our authorized dealers.
Remove the jammed card. (
A
Page 32 “Card Jam”)
●
●
05000052 Card jam near the card outlet.
05000053 Top side film has run out.
Replace the laminate film with a new one.
●
05000054 Bottom side film has run out.
05000055 Top side film is broken or is not detected.
Check to ensure that the laminate film is correctly
set.
Check to ensure that the type of laminate film in use
and the settings are appropriate.
●
●
05000056 Bottom side film is broken or is not detected.
05000057 Mark on top side film is not detected.
Check to ensure that the laminate film is correctly
set.
●
05000058 Mark on bottom side film is not detected.
05000059 The laminator door is open.
Close the laminator door. If initialization does not
start even after closing the laminator door, press the
operation button to initialize.
●
0500005A The film cassette is detached. Insert the film cassette for the side to be laminated.
●
05000060 Thermostat is broken.
Turn off the power and turn it on again. If the same
problem occurs, consult our authorized dealers or
servicing personnel.
●
05000061 The temperature of the top side Heat Roller is too high.
05000062
The temperature of the bottom side Heat Roller is too
high.
05000063
The internal temperature of the top side Heater is too
high.
05000064
The internal temperature of the bottom side Heater is
too high.
05000065
A hardware error has occurred in the top side Heat
Roller.
05000066
A hardware error has occurred in the bottom side Heat
Roller.
05000067 The thermistor of the top side Heat Roller is faulty.
05000068 The thermistor of the bottom side Heat Roller is faulty.
0500006B A cam error has occurred in the top side Heat Roller.
0500006C
A cam error has occurred in the bottom side Heat
Roller.
0500006D
The operating ambient temperature of the laminator is
too low.
Use the laminator within the prescribed range.
When starting up the laminator in a low temperature
environment, the temperature of the interior
may remain low even though the surrounding
temperature has gone up. Turn on the power again
after waiting for about one hour.
●
0500006E
A hardware error has occurred in the top side Film
Supply Encoder.
Turn off the power and turn it on again. If the same
problem occurs, consult our authorized dealers or
servicing personnel.
●
0500006F
A hardware error has occurred in the bottom side Film
Supply Encoder.
05000070
A hardware error has occurred in the top side Film
Takeup Encoder.
05000071
A hardware error has occurred in the bottom side Film
Takeup Encoder.
0500007D Other error is detected.
■
To Next Page
Loading...