Factory Settings
Item Factory Settings
Mode Laminate
Film-T Patch
Film-B Patch
Film-T Pos 0
Film-B Pos 0
HR-T Temp 140 degC
HR-B Temp 140 degC
Speed 7.0 mm/s
Cooling Time 0sec
Count
0
Initializing
Performing the operations below will reset the laminator
settings. Thereafter, when the heating roller is adjusted
to the preset temperature, a [Ready] message will be
displayed and laminating can be performed.
Turning On the Power
Turning on the power when the laminate film is loaded will
reset the laminator settings.
■
●
●
Closing the Laminator Door
Closing the laminator door when the laminate film is
loaded will reset the laminator settings.
Loading a patch film will forward the laminate film by one
image and reset the laminator settings.
Cautions:
If the loading statuses of the top side and bottom side film
cassettes change when opening and closing the laminator
door, initialization may not be performed when the
laminator door is closed. In this case, press the operation
button to initialize.
Pressing the Operation Button
Pressing the operation button when the laminate film is
loaded will reset the laminator settings.
Loading a patch film will forward the laminate film by one
image and reset the laminator settings.
●
●
●
●
●
To Next Page
Loading...