MAGNER100 USER MANUAL
Magner INT 23
1. BAUD RATE Set up the baud rate between machine and printer.
2.PAPER SIZE Set up the size of printer paper.
3. FONT Set up the font size
4. BLANK OF TAIL User set up the blank of tail.
5. PRINT NUMBER Set up number of receipt.
6. PAPER CUTTING Set up cutting paper automatically or manually.
2. USER ID:
Enter user ID to machine.
LEVEL and CURRENCY Key: Move position.
ADD and SET Key: Select characters.
3. ID PRINT
Select to print ID to receipt or not.
4. LCD LANGUAGE
Select displayed language on screen.
5. SP SELECT
In SP Mode, machine recognized first note continuously or not.
REFRESH: After stop, machine remembers next inserted note again.
CONTINUE: Machine memorizes the first note continuously.
6. WARNING BUZ
If select ON, when error is caused, machine makes a beep.
7. CF KEY
Select to use CF function or not. But this function is always on. (LOCK)
8. COMMA
If select ENABLE, display shows COMMA by the thousand.
9. STOP STAGE
When
! appears and hopper has nothing, if select REMOVE, machine works again
to remove a note from inside. If select HOLD, machine doesn’t work before remove
notes from Stacker.
10. STACKER BRAKE
If select ON, when error appears, machine stops the stacker before the error note
goes to Stacker pocket.
To Next Page
