Flex VUE™ Transmitter Instruction Manual
July 2013
Page 22 of 41
4.3.4 Transmitter Inactivity Timeout
This setting controls the amount of time that the transmitter can be inactive before it automatically shuts
off.
The Timeout time can be set from Disabled to 60 minutes. From Disabled to 15 minutes the timeout can
be set in 1 minute increments. From 15 minutes to 60 minutes it can be set in 5 minute increments.
When the unit times out, the transmitter will turn off. The Flex VUE™ unit will need to be turned off and
then back on to start the unit again.
If ‘Save and Exit’ is selected from the setup menu after changing this parameter, it will immediately take
effect.
WARNING
DO NOT ASSUME THE POWER IS OFF IN THE RECEIVER BECAUSE THE TRANSMITTER IS TURNED OFF.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
4.3.5 Backlight Power %
The Backlight Power percentage setting controls the brightness of the backlight on the Flex VUE™
transmitter.
The Backlight Power can be set from ‘Backlight Off’ (0%) to 100%, in 5% increments.
If ‘Save and Exit’ is selected from the setup menu after changing this parameter, it will immediately take
effect.
4.3.6 Backlight Timeout
The Backlight Timeout setting controls the amount of time that the backlight will stay on after a command
is pressed before it automatically shuts off.
Backlight Timeout can be set from ‘Always On’ to 30 seconds, in 1 second increments.
If ‘Save and Exit’ is selected from the setup menu after changing this parameter, it will immediately take
effect.
NOTE: Leaving the backlight on longer will decrease the battery run time and will require more frequent
battery replacement.
To Next Page
