Magneti Marelli OZON MAKER - Standard Procedure; Operating Manual - Car Cabin Disinfection; How to Park the Car Which Is to be Disinfected

IEC 60335-2-60: 1997 “Safety of Household and Similar Electrical Appliances; Part 2: Particular
Requirements for Whirpool Baths”
IEC 61000-4-2: 1995 “Electromagnetic Compatibility (EMC) – Part 4: Testing and measurement
techniques – Section 4: Electrostatic discharge immunity test”
IEC 61000-4-4: 1995 “Electromagnetic Compatibility (EMC) – Part 4: Testing and measurement
techniques – Section 4: Electrical fast transient/burst immunity test – Basic EMC publication”
IEC 61000-4-6: 1996 “Electromagnetic Compatibility (EMC) – Part 4: Testing and measurement
techniques – Section 6: Immunity to conducted disturbances induced by radio-frequency
Fields”
IEC 61000-4-11: 1996 “Electromagnetic Compatibility (EMC) – Part 4: Testing and measurement
techniques – Section 11: Voltage dips, short interruptions and voltage
variations immunity tests”.
Signed by: Mr. D. Lavelle (manager) Via Ponte, 83 – Pescantina (VR)
OPERATING MANUAL – CAR CABIN DISINFECTION
NOTE – Please read the following instructions carefully.
NOTE – Nobody may stay in the cabin during the disinfection process.
After the disinfection process is finished, the cabin shall be ventilated for 10-15 minutes.
HOW TO PARK THE CAR WHICH IS TO BE DISINFECTED
IMPORTANT – the disinfection operation shall not be performed in the car which is strongly effected by the sun rays, as
ozone quickly degenerates in the temperature above 25°C and is much less effective. In the case the temperature in the
cabin exceeds 25°, it is recommended to cool it before the disinfection operation.
IMPORTANT – the car shall be parked in a place where it may be stood for the whole period of disinfection causing no
obstacle.
IMPORTANT – all fragrance accessories (air fresheners and other perfumes) shall be removed from the cabin.
STANDARD PROCEDURE
1. Place the device horizontally outside the car, next to the driver’s or front passenger’s door, and connect it to the
electric power outlet of 220V.
2. Set the air cycle to the constant circulation with the airflow blower set to minimum speed to enable disinfection of the
whole cycle. If possible, it is recommended to place a dust filter (even if new) inside the cabin.
3. On the rear-view mirror put the tube with a porous ceramic distribution tip, leading a connecting tube through the door
window. The window shall not be fully closed to prevent the tube squeezing. Then, turn the Ozon Maker device for 30
minutes (and afterwards ventilate the cabin for 10-15 minutes).