8
MIPS
Important : Do not connect the camera to the
computer before installing the Software
Both the Viewer Software and driver are installed from the
software CD provided.
The Viewer Software Installation
will take place automatically when the CD is inserted into a
CD drive on the computer, and the driver will be automatically
loaded when the camera is connected to the computer.
Installing & Using The Camera
Driver Installation
To install the driver you first need to
connect the camera
to a USB port on the computer.
When the computer detects the camera, the New Hardware
Wizard will automatically be launched.
Select the Install the Software Automatically and click on
the Next Button. Select the Continue Anyway option.
The driver installation is now complete. Simply click on the
Finish button to exit the hardware wizard.
Please go through Software Installation Steps
Connect MIPS to
USB2 Port of PC or Laptop
To Next Page
Loading...