Magtek eDynamo - Security and Electrical Characteristics; Connectivity and Software Compatibility

Appendix A - Technical Specifications
eDynamo| Secure Card Reader Authenticator | Installation and Operation Manual
Page 33 of 34 (D998200110-23)
eDynamo Technical Specifications
Keypad:
Not Applicable
Security Characteristics
Ingress Protection:
ANSI/ISO 60529 ingress protection rating 30
Tamper Protection:
Secure Cryptographic Device (SCD) with Tamper Resistant Security
Module (TRSM).
Code Protection:
Signed firmware. Any attempt to install unsigned firmware on the
device will render it unusable.
Eavesdrop Protection:
Main processor encryption
Tamper-evident enclosure around data signals
Electrical Characteristics
Power Inputs:
USB powered via Micro-USB B jack
Battery Type:
Rechargeable Li-ion (main device power)
Coin cell backup battery
Battery Capacity:
800 mAH nominal
Battery Charge Time:
Approximately 3 hours to full charge
Battery Time, Airplane Mode:
6 months minimum
Battery Time, Transactions:
1900 swipes over 8 hours
1300 insertions over 5.5 hours
Voltage Requirements:
5 VDC on USB power
3.7 VDC on battery power
Maximum Current Draw:
< 100 mA battery discharge rate when not charging
~500 mA battery charge rate when connected to USB charger
Data Storage:
Not Applicable
Connection Characteristics
Wired Connection Types:
Micro-USB B, compatible with USB 1.1, USB 2.0
Vendor-defined USB Human Interface Device (HID) data format
Wireless Connection Types:
Bluetooth Low Energy (Bluetooth LE) wireless
GATT device / data format
Wireless Range:
Minimum 30 ft. or 10 m in line-of-sight conditions
Wireless Frequency:
2.4 GHz