MAHA HL CS Series - User Manual

Questions and Answers

M
Michael PriceAug 12, 2025
What to do if my MAHA Lifting Systems motor starts but won't lift the load?
- J
  Jeremy BlackAug 12, 2025
  If the motor starts but the pressure is insufficient to raise the load on your MAHA Lifting Systems, several factors could be at play. First, check the fluid level and top it up if needed. The load on the lift might be too heavy, so reduce it, keeping within the rated load capacity. Other potential causes include reverse motor operation, a permanently open lowering valve, or hydraulic system leakage, but for these you should contact service to resolve the issue and remove any leakage.
L
Lisa ParrishAug 19, 2025
What to do if MAHA Lifting Systems lift cannot be lowered?
- M
  Monica DeleonAug 19, 2025
  If your MAHA Lifting Systems lift cannot be lowered, it might be engaged on mechanical locks. Try raising the lift out of the mechanical locks. If that doesn't work, the latch release or lowering valve might be defective, but for these you should contact service.
J
Jeremiah HarrisAug 27, 2025
How to fix a MAHA HL CS Lifting Systems that does not respond?
- T
  thompsonjodiAug 27, 2025
  If your MAHA Lifting Systems lift does not respond, start by checking if the main switch is turned on. If it is, the mains fuse might be defective and require replacement.
C
Carla WilliamsSep 2, 2025
Why is there a height difference between MAHA Lifting Systems carriages?
- D
  Derek ConradSep 3, 2025
  If the maximum height difference (±25 mm) between the carriages of your MAHA Lifting Systems is exceeded, the equalizing ropes may be maladjusted, but for this you should contact service.