MAHA ZS SQUARE II Series

Questions and Answers

J
Jennifer SimmonsAug 10, 2025
What to do if my MAHA ZS SQUARE II Lifting Systems lift does not respond?
- J
  Jenny DrakeAug 10, 2025
  If your MAHA Lifting System isn't responding, there are several potential causes: * The main switch might be off: Turn on the main switch. * The emergency stop switch on the remote control could be activated: Unlock the emergency stop switch. * A mains fuse might have blown: Replace the mains fuse. * The primary fuse F1 of the power supply -T1 could be blown: Replace fuse F1. * Secondary fuses of the power supply -T1 might be blown: Replace the fuses. * The ceiling light barrier +D-B1 (if installed) could be dirty: Carefully clean the light barrier.
M
Mr. Joshua LeeAug 15, 2025
Why is my MAHA ZS SQUARE II motor running, but the lift won't raise?
- W
  William CoxAug 15, 2025
  If the motor of your MAHA Lifting Systems is running but the lift isn't raising, consider these possibilities: * The pressure relief valve might be set too low: Contact service. * The hydraulic system could be leaking: Remove leakage, contact service. * The fluid level might be low: Check the fluid level and top up as needed. * The vehicle might be too heavy: Reduce the load and ensure you're within the rated load capacity.
R
Rebecca JacksonAug 19, 2025
How to fix a MAHA ZS SQUARE II Lifting Systems lift that cannot be fully raised?
- L
  Linda TranAug 20, 2025
  If your MAHA Lifting Systems lift cannot be fully raised, it may be due to a low fluid level. Check the fluid level and top up as required.
E
ellisamyAug 25, 2025
Why does my MAHA Lifting Systems lift show jerky movements?
- C
  Carolyn MatthewsAug 26, 2025
  Jerky movements in your MAHA Lifting Systems lift can be caused by air in the hydraulic system. Bleed the cylinders to resolve this.
M
Melissa MorrisAug 30, 2025
What to do if MAHA ZS SQUARE II Lifting Systems lift with pneumatic floor cover and axle jack cannot be fully lowered?
- H
  heathermooreAug 30, 2025
  If your MAHA Lifting Systems lift with pneumatic floor cover and axle jack cannot be fully lowered: * The axle jack may not be in the rest position: Move the axle jack to the rest position. * The position switch for the axle jack may be defective or maladjusted: Contact service.
C
Catherine FieldsSep 4, 2025
How to fix MAHA ZS SQUARE II Lifting Systems lighting between runways that does not burn?
- K
  kennethowensSep 4, 2025
  If the lighting between the runways of your MAHA Lifting Systems does not illuminate, the fuse F2 may be defective. Replace fuse F2.