MAHA Twin Series - User Manual

Questions and Answers

B
Brittany AdamsAug 1, 2025
Why my MAHA Scissor Lifts does not raise?
- C
  Connie GarciaAug 1, 2025
  If your MAHA Scissor Lift doesn't raise, it could be due to several reasons. The motor direction of rotation might be incorrect, in which case you should interchange the two phases on the main switch. Alternatively, the hydraulic oil level might be insufficient, requiring you to add more hydraulic oil. Other potential causes include a faulty printed circuit board (replace it), a faulty UP button (check and replace if needed), a faulty maximum height limit switch sensor (check and replace if needed), a lowering valve that doesn't close (check, clean, or replace), or a dirty suction pump filter (check and clean it).
S
Steven SmithAug 5, 2025
What to do if MAHA Twin Scissor Lifts does not lower when the DOWN button is pressed?
- J
  John PerezAug 6, 2025
  If your MAHA Scissor Lift does not lower when you press the DOWN button, several issues could be the cause. A jammed locking solenoid valve may be the culprit; verify if it's powered and check the magneto for damage, replacing it if disconnected or blown. The DOWN button itself might be faulty and need replacement. Another possibility is a malfunctioning printed circuit board, which would also require replacement. Lastly, the lowering solenoid valve might not be working correctly; verify if it's powered and check the magneto for damage, replacing if necessary.
T
Tracy KellerAug 10, 2025
Why MAHA Twin Scissor Lifts lifting capacity is not sufficient?
- W
  William NortonAug 10, 2025
  If your MAHA Scissor Lift's lifting capacity is insufficient, the maximum pressure valve may not be properly set; in this case, set the maximum pressure valve. Alternatively, the pump could be faulty, requiring you to check and replace it if needed.
M
Matthew TaylorAug 14, 2025
What to do if MAHA Twin platforms do not stop in standing position?
- P
  prattkristenAug 14, 2025
  If your MAHA Scissor Lift platforms do not stop in the standing position, it could be due to several reasons. The lowering and locking solenoid valves might be stuck open; verify that the solenoid valve sliders are not blocked. There could also be leakage in at least two hydraulic pipelines; check the connections for proper tightening and inspect the tubes for damage, replacing them if necessary. Alternatively, at least two hydraulic cylinders might be faulty; check and replace them if needed.
M
Michael MartinezAug 18, 2025
What to do if MAHA Twin Scissor Lifts doesn’t low pushing the DOWN button (without load)?
- R
  Rita CrawfordAug 19, 2025
  If your MAHA Scissor Lift doesn’t lower when pushing the DOWN button (without load), it may be due to an excess of oil in the hydraulic circuit. To resolve this, push the DOWN button and the oil discharge button simultaneously.
M
Mr. Anthony PeckAug 22, 2025
Why MAHA Twin does not lower smoothly?
- R
  Rebecca GonzalezAug 22, 2025
  If your MAHA Scissor Lift does not lower smoothly, there may be air in the hydraulic system. Bleed the hydraulic system to resolve this issue.
S
Sara ChambersAug 27, 2025
Why lifting is not synchronised on MAHA Scissor Lifts?
- L
  Laura ThompsonAug 27, 2025
  If lifting with your MAHA Scissor Lift is not synchronized, it could be due to leakage or air in the hydraulic system. Bleed the hydraulic system to resolve this.