B-24
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Removal & Refitment of Alternator
REMOVING THE ALTERNATOR BELT
1. Loosen the Alternator mounting bracket bolt
and bolt locking the adjustable brace.
2. Push the Alternator towards the engine to slacken
the belt tension and remove the belt from the
Alternator pulley.
3. Remove the belt from main drive pulley.
4. Take out the belt from Radiator cowl, top slot
space and fan blades.
ALTERNATOR INSTALLATION
1. Install the Alternator drive belt by reversing the
procedure.
2. Refit the removed parts in the reverse sequence
of removal.
3. Refit the Battery Negative cable only at the end
of refitment.
ADJUSTING TENSION DRIVE BELT
1. Check the drive belt tension by pressing with the
thumb midway between the pulleys.
2. The belt slack should be approximately ¼”.
If the belt tension is found to be incorrect then
adjust the belt tension as below:
a. Loosen the Alternator mounting bolt and bolt
locking the adjustable brace.
b. Move the Alternator away from the engine to
increase belt tension or push it towards the
engine to decrease the tension.
c. When the required tension is obtained, retighten
the Alternator mounting bracket bolt and the
adjustable brace locking bolt.
NOTE: To avoid damage to charging system,
service precautions should be observed as
follows. Never make or break any of the
charging circuit connections, including the
battery when engine is running never short
any of charging components to ground.
Do not use a slave battery of higher
than 12 volts nominal voltage.
Always disconnect the battery ground cable
before carrying out arc welding on the
tractor or any implements attached to the
Tractor.
To Next Page
Loading...
Need help?
General
