C-39
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Connecting Rods, Pistons & Cylinder Sleeves
Space the bolts to obtain uniform pressure
on the sleeve flange as shown in figure.
Torque the bolts equally in three stage as
specified torque.
3. Place a dial indicator with block, across the
cylinder sleeve.
4. With dial indicator pointer set on the flange
of the cylinder sleeve. Adjust the indicator
to zero.
Move the indicator block until the pointer
drops to the crankcase deck and check the
reading.
5. Take a reading three or four points around
the sleeve and use the average reading
normally the top of sleeve will extend
0.076mm - 0.18mm above the cylinder block
surface.
6. Mark each sleeve before removing so that
it can be reinstalled in the same bore and
in the same position.
To Next Page
Loading...
Need help?
General
