35 Series-HST, Model - 3535, 4035, 4535 & 5035
21
Use Of ROPS And Seat Belt
The Roll Over Protective Structure (ROPS) has been certified
to industry and/or government standards. Any damage or
alteration to the ROPS, Mounting hardware, or Seat belt
voids the certification and will reduce or eliminate
protection for the operator in the event of a roll-over. The
ROPS, mounting hardware, and seat belt should be checked
after the first 100 hours of tractor operation and every
500 hours thereafter for any evidence of damage, wear or
cracks. In the event of damage or alteration, the ROPS must
be replaced prior to further operation of the tractor.
The seat belt must be worn during machine operation when
the machine is equipped with a certified ROPS. Failure to do
so will reduce or eliminate protection for the operator in
the event of a roll-over.
Park Tractor Safely
Before parking the tractor :
Lower all equipments to the ground, bring transmission in
neutral. Engage the parking brake. Stop the engine and
remove the key.
Keep Riders Off Tractor
Do not allow riders on the tractor.
Riders on tractors are subject to injury such as being struck
by foreign objects and being thrown off from the tractor.
Handle Fuel Safely — Avoid Fires
Handle fuel with care. It is highly flammable. Do not refuel
the tractor while smoking or near open flame or sparks.
Always stop engine before refueling tractors.
Always keep your tractor clean of accumulated grease and
debris. Always clean up spilled fuel.
Stay Clear of Rotating Shafts
Entanglement in rotating shaft can cause serious injury or
death.
Keep PTO shields in place at all times.
Wear close fitting clothing. Stop the engine and be sure
PTO drive is stopped before making adjustments,
connections, or cleaning out PTO driven equipment.
Safety Instructions
To Next Page
Loading...
Need help?
General