35 Series-HST, Model - 3535, 4035, 4535 & 5035
53
Attachments
Drawbar
Tractor is equipped with a drawbar (B) for connecting to
pull behind implements. It can be set at two positions.
Attaching PTO Driven Implement
1. Turn key to "OFF" position.
2. Position PTO switch in OFF position.
3. Position the drawbar according to the requirement of
implement and driveline.
4. Attach implement to tractor before connecting PTO
driveline.
5. Remove PTO shield (A) for clearance.
6. With the engine still OFF, turn the shaft slightly by hand
if necessary to line up splines. Connect driveline to PTO
shaft. Pull out on shaft to be sure driveline is locked to
PTO shaft.
7. Reassemble the PTO shield.
Rear roll-over can result if pulling from wrong
location on tractor. Hitch only to drawbar.
Use 3 point hitch only with implements
designed for its use, not as a drawbar.
Try to balance the load primarily on the
implement wheels. Avoid overloading the
drawbar. Ballast the tractor for improved
stability. Engage the clutch smoothly, avoid
jerking and use brakes cautiously to avoid jack-
knifing.
A
B
To Next Page
Loading...
Need help?
General