15
2.0 SAFETY AND ACCIDENT
PREVENTING PROVISIONS
44) Lengthy use of the machine can, as secondary effect, overheat the overdrive and parts of the hydraulic circuit.
Never touch these parts immediately after use as they are very hot and can cause burns.
45) Never carry out maintenance or cleaning work unless the pto has been disengaged, the engine switched off, the
hand brake engaged.
Periodically check the state and condition of the protection bars and the protection flap bar.
46) Periodically check that all nuts and bolts are fully tightened. Re-tighten them if necessary.
47) Always place adequate supports under the implement when servicing the machine or replacing the hoe blades
with the implement raised.
48) Before working on the cutting tools, disengage the pto, switch off the tractor engine, engage the hand brake and
check that the blades are completely at a standstill.
49) Only use the recommended oils.
50) The spare parts must correspond to the requirements established by the manufacturer. Only use genuine spare
parts.
51) The safety transfers must always be perfectly visible. They must be kept clean and should be replaced if they
become illegible. Replacements are available on request from your local dealer.
52) The instruction manual delivered toghether with the machine by the dealer must be kept for as long as the
machine lasts.
ATTENTION
In the event a tractor is used that has no pressurized, soundproof cabin the operator must use individual
methods of protection.
- Protective headphones for noise in case the standard levels of exposure are exceeded.
- Anti-dust mask, if a considerable quantity of dust is raised caused by the type of product cut, by very dusty earth,
or by the use of an open machine.
To Next Page
Loading...
Need help?
General