Mahindra Gyrovator SLX Series User Manual

- Shorten the sliding tubes by the same extent (Fig. 14 and 15), deburr and trim, then grease the inside of the
outer tube.
- Make sure that the upper hitch bar is as parallel as possible to the lower bars of the hitch.
If this is not sufficient, correct the way the top link of the hitch couples to the tractor or machine, as necessary, or
at least considerably attenuate, the jolts to which the driveline shaft is subjected during the lifting phase.
- If errors have been committed, disengage the tractor's PTO before lifting the machine.
Repeat these inspections when the machine is hitched behind another tractor.
CAUTION
When the propeller shaft is fully extended, the two tubes must overlap by at least 15 cm.
When fully inserted, the minimum play must be 4 cm. (A Fig. 13).
CAUTION
If the implement is used on another tractor, always check the before and that the guards completely cover
the rotating parts of the propeller shaft.
21
3.0 USE INSTRUCTIONS
Fig. 14
Fig. 15
Fig. 16
Fig. 17

Mahindra Gyrovator SLX Series Specifications

General

Brand	Mahindra
Model	Gyrovator SLX Series
Category	Farm Equipment
Language	English