13-8
© Copyright Mahindra & Mahindra Ltd.042015
• Oil levels above the ‘Max’ mark may cause engine damage/poor performance.
• Put the dipstick and the oil filler cap back and ensure it is fully/properly seated.
To avoid possible oil loss and injury due to hot blow-by gas, DO NOT operate the
vehicle with the engine oil level dipstick and/or the engine oil filler cap removed.
Draining/Changing of engine oil should always be done by an Authorized
Mahindra Dealer.
13.5.5 Checking/Topping Engine Coolant Level
• Park the vehicle on a flat-horizontal surface. Keep the parking brake fully engaged.
Shut-off the engine
• Wait till the engine cools down and hence coolant temperature comes down to
normal room temperature
• The coolant level should be between ‘MIN’ and ‘MAX’ marking provided on the
coolant recovery tank
• In case the coolant level is below the ‘MIN’ marking, the coolant should be topped-
up
• The coolant should be filled till the level rises above the ‘MIN’ but remain below the
‘MAX’ marking on the coolant recovery tank
• However if the Coolant Recovery Tank is found to be near empty, it is
recommended that the system be checked at an Authorized Mahindra Dealer
Never open the pressure cap when the engine is hot. Hot coolant may splash
resulting in serious personal injury or severe burns by the erupting liquid.
Top up only with recommended Ready-To-Use (RTU) coolants for ensuring
performance, anti-freezing and corrosion protection. Do not add water directly.
MAINTENANCE
To Next Page
Loading...
