To Next PageTo Next Page
Need help?Do you have a question about the Mahlkonig E80S and is the answer not in the manual?
General| Burr Type | Flat |
|---|---|
| Burr Diameter | 80 mm |
| Burr Material | Steel |
| Grinding Adjustment | Stepless |
| Voltage | 220-240 V |
| Frequency | 50/60 Hz |
| Type | Espresso Grinder |
Instructions on reading the manual for safe and correct operation.
Explains symbols and signal words in the manual and on the grinder.
Specifies the grinder's purpose and limitations for safe operation.
Essential safety precautions and warnings for operating the grinder.
Explains DDD, dosage, and automatic/manual grinding modes.
Guide for checking the grinder and its components after unpacking.
Step-by-step guide to attaching the bean hopper to the grinder.
Instructions for adjusting the portafilter support and aligning the spout.
Guidance on filling the bean hopper with espresso beans.
Steps to correctly switch on the grinder and prepare it for operation.
How to adjust the grinding degree using the slider and lock.
Instructions on selecting a desired recipe using the controller.
Guide to modifying recipes or setting new grinding times.
How to start grinding using recipes or manual control.
Procedure to interrupt and resume or cancel the grinding process.
Using the rescue button in case of display failure.
Steps to empty and refill the hopper with a different bean type.
Guide to navigating the main menu for device data and settings.
Explanation of symbols used in the display and for navigation.
Instructions for entering and exiting the grinder's main menu.
Instructions for cleaning the surface where the grinder is installed.
Steps for cleaning the exterior casing and collecting tray.
Procedure for cleaning the spout system using a brush.
Daily cleaning procedure for the bean hopper to maintain coffee taste.
Using GRINDZ™ cleaner for the grinding mechanism every 2-5 days.
Manual cleaning of the grinding mechanism, including burrs and chamber.
Instructions for cleaning or replacing the flapper.
Guide on when and how to change the grinder burrs.
Procedure for adjusting the burrs after replacement or for calibration.
Steps for replacing the flapper if it becomes porous or dirty.
Instructions for proper disposal of product packaging.
Legal obligations and methods for environmentally sound disposal of old grinders.
