maimin SABRE 2000 - Grounding Instructions

When
using
your
cutting
machine,
basic
safety
instructions
should
always
be followed
including
the following:
This cutting
machine
is for
commercial
use
only. Read
all
instructions
before
using.
DANGER--to
reduce
the risk
of electric
shock:
1.
Do
not
install
or store this
machine
in
a wet location.
WARNING--Io
reduce
the risk
of btrns,
fire,
electric
shock,
or
injury
to
persons:
use machine
only for
its
intended
use as
a
portable
cutting
machine.
Turn
machine
to
"oFF"(o)
before connecting
or disconnecting power
cord.
Connect
this
machine
to a
properly
grounded
outlet
only.
See Grounding
Instructions.
Always
disconnect
electrical
connector from
machine
when
not
using it,
before
servicing
it,
or
changing
blade.
Do
not leave
machine
unattended
while it
is
connected
to
power
outlet.
Do not
operate machine
with
a
damaged
cord or if
machine
has
been
dropped.
Do not
disassemble
--
take
to
a
qualified
serviceman
for refairs.
Incorrect
assembly
can
cause
electric
shock
when
the
machine
is
used.
Keep
hands
and fingers
away from
blade and
moving
parts.
Keep
guards
in
place
and in
working
order,
The
knife
key
and
other
wrenches
must
be
removed
from
machine
before
starting
the
motor.
Keep
ventilation
openings
of machine
free from
dust
and lint.
Keep
machine
clean
and
blade
sharp for
best and
safest
performance.
5.
6.
l.
2.
3.
4.
7.
8.
9.
10.
11.
SAVE
THESE
INSTRUCTIONS
GROUNDING
INSTRUCTIONS
This
machine
must
be
grounded.
In
the event
of malfunction
or
breakdown,
grounding
provides
a
path
of
least
resistance
for
electric
current
to reduce
the risk
of electric
shock.
This
machine
ii
equipped
with
a
Ground
Shield
surrounding
the Terminal
Pins;
this
Ground
Shield is
designed
to
be used
with
a Maimin
Grounded
Connector, part
#4584
or
4588.
See
Wiring instructions
supplied
with the
Connector.
D
{NGER
--
Improper
connection
of the
Maimin
Connector
can
result
in a risk
of electric
shock.
Check
with
a
qualified
electrician
or service
man if
the
grounding
instructions
are
not
completely
understood
or if in
doubt
as to
whether
the machine
is
properly
grounded.
Do
not modifu
the
Ground
Shield
provided
with this
machine.
Use correct
wire
sizes with
the
Maimin
Grounded
Connector.
U.S.A.
only: I
Phase:
Use AWG
1613
SJ, SJT
or
SJE
3
Phase:
Use
AWG
16/4
SJ,
SJT
or SJE
International:
I P+N+:
Use 3Xl,
Omm
CEE
(2)
6l
'
3 F+:
Use 4X1,
Omm
CEE
(2)
61
lI. Maimin
Co.,Inc.
P.O.
Box
549
Route 341
Kent,
CT 06757
U.S.A.
Printed
in U.S.A