CAUTIONS
• Improper use of this meter can cause damage, shock,
injury or death. Read and understand this user manual
before operating the meter.
• Always remove the test leads before replacing the
battery or fuses.
• Inspect the condition of the test leads and the meter
itself for any damage before operating the meter.
Repair or replace any damage before use.
• Use great care when making measurements if the
voltages are greater than 25VAC rms or 35VDC. These
voltages are considered a shock hazard.
• Always discharge capacitors and remove power from
the device under test before performing Diode,
Resistance or Continuity tests.
• Voltage checks on electrical outlets can be difficult and
misleading because of the uncertainty of connection to
the recessed electrical contacts. Other means should
be used to ensure that the terminals are not "live".
• If the equipment is used in a manner not specified by
the manufacturer, the protection provided by the
equipment may be impaired.
To Next Page
Loading...
Need help?
General
