Introduction
A5.02
M20/M25/M32/M43
en / 14.12.2010 AA047605 10/15
WARNING
Keep all handles, steps, handrails, platforms, ladders free from dirt, e.g. oil,
grease, fuel!
Use only suitable and technically perfect lifting gear and suspension systems
with adequate lifting capacity!
Never work or stand under suspended loads!
During replacement work, individual parts and large assemblies are to be ca-
refully fastened and secured on hoists to avoid risks of accidents!
Re-install removed guards and protecting devices on completion of work.
When carrying out overhead assembly work, the specially designed or safe-
ty-oriented climbing aids are to be used only!
Do not use engine/plant parts for climbing on!
Use personal protective equipment as far as necessary or as required by the
regulations!
Pressurized plant components (lube oil, hydraulic oil, fuel, cooling water, star-
ting and control air) must be depressurized. Shut-off valves are to be secured
by a plate “Do not open”!
When work is being carried out on engines and systems, the switch-on de-
vices have to be switched off and protected. In order to prevent reconnection,
the engines and systems have to be marked with a plate “Do not switch” or
an appropriate pictogram plate!
Mounting openings are to be protected!
Replaced seals should be disposed of immediately, and above all, it should
be taken care that this material is not overheated even by accident e.g. du-
ring combustion and welding operations. If this should however has happen-
ed, the gases emitted must not be inhaled. Skin contact with decomposed
VITONR is to be avoided at all times. After a fire with VITONR, it is essential
that neoprene gloves are worn during the clearing up operations.
To Next Page
Loading...