Introduction
A5.02
M20/M25/M32/M43
en / 14.12.2010 AA047605 13/15
3.4 Working with hydraulic devices
3.5 Checking and adjustment of injection valve
WARNING
Do not place parts of your body above/below pressurized hydraulic tools!
Replace hydraulic hose lines at regular intervals, even if no safety relevant
defects are detectable!
Operating instructions, tightening torques and setting dimensions specified in
the appropriate job card are to be carefully observed!
The minimum bending radius of the high-pressure hoses are to be strictly ob-
served!
The hose lines are to be protected against damage caused by external
mechanical, thermal or chemical influences!
CAUTION
During testing make sure that no parts of your body are positioned in the area of the
fuel jet!
Do not inhale the fuel mist - respiratory mask!
To Next Page