Emergency Stop
Safety System
A0.04
M20/M25/M32/M43
en / 15.12.2010 AA033984 1/5
Actions that must be performed after a safety/emergency stop* occurred:
- Identify the reason for emergency stop based on the points listed below.
- Work through list of corresponding sub-points.
- Contact your Caterpillar Service.
Type of emergency stop:
1. Overspeed condition
2. Lubrication oil (pressure and temperature)
3. Engine room monitoring
4. Cooling water - fresh water - HT (pressure and temperature)
5. Exhaust gas
6. Check pneumatic emergency stop system on engine after every emergency stop
7. Fault messages and measuring points
WARNING
Do not perform further starting attempts for a while after the safety/emergency stop
device has triggered!
Note and observe the following points and actions.
If these actions are not observed, severe personal injuries as well as damage to the
engine can occur, which may void the warranty.
NOTE
*
With some engine assemblies, in particular in marine applications, an alarm or a po-
wer reduction may be triggered before a safety/emergency stop is performed. If there
are no safety concerns, the engine must also be shut down, if an alarm occurs or en-
gine power is reduced and the causes have to be eliminated.
To Next Page
Loading...