Need help?Do you have a question about the MAKERGEAR M2 and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Bed Temperature | Up to 120°C |
| Nozzle Temperature | Up to 300°C |
| Nozzle Diameter | 0.35 mm |
| Print Speed | Up to 200 mm/s |
| Materials Supported | PLA, ABS, PETG, Nylon, Polycarbonate |
| Frame Material | Steel |
| Software | Simplify3D, Cura |
| Power Requirements | 110-240 V |
| Layer Resolution | 20 microns |
To Next Page
