Need help?Do you have a question about the MAKERGEAR M2 and is the answer not in the manual?
General| Filament Diameter | 1.75 mm |
|---|---|
| Connectivity | USB, SD Card |
| Heated Bed | Yes |
| Bed Temperature | Up to 120°C |
| Nozzle Temperature | Up to 300°C |
| Nozzle Diameter | 0.35 mm |
| Print Speed | Up to 200 mm/s |
| Materials Supported | PLA, ABS, PETG, Nylon, Polycarbonate |
| Frame Material | Steel |
| Software | Simplify3D, Cura |
| Power Requirements | 110-240 V |
| Layer Resolution | 20 microns |
Essential safety guidelines for operating the 3D printer, covering electrical shock, child supervision, and handling moving parts.
Tasks to perform every 50 hours of operation, focusing on bed leveling and surface cleaning.
Tasks for every 200-250 hours, including cleaning dust, debris, and lubricating rails.
To Next Page
