1
WELCOME
Your MakerGear M2 3D Printer has arrived!
Do not change your M2's firmware unless you
know exactly what you're doing or have been
instructed to do so by MakerGear Support.
Do not remove the film of yellow polyimide
tape from your M2's glass bed; this functions as
your print surface, and should be facing up.
With the exception of minimal set up, your M2 is ready
to print out-of-the-box. To ensure both safety and
high quality printing, carefully follow the Set Up
instructions included in this booklet. This machine was
assembled and tested at the MakerGear shop in
Beachwood, Ohio, USA and was fully operational at
the time that it was shipped, as demonstrated by the
sample objects included with your M2—these were
printed on your machine before shipping. This booklet
can also be found on the MakerGear website at
www.makergear.com/pages/m2-assembled, where
you can also access more specific instructions and
resources.
To Next Page
Loading...
