5
Set Up
Carefully remove the foam from the top of the printer
and from inside the printer frame. Remove the HBP
from its slot in the foam and place it on the 4 legged
“Spider” inside the frame, with the glass facing up.
Remove the printer from the bottom foam. Remove
(and please read) WARNING sheet from underneath your
glass bed by removing the binder clip. Rotate the bed
hold-down clips to point toward the front and back of
the bed in order to secure the glass in place.
Unpack the power supply and set the Voltage Switch to
the voltage supplied through your outlet. There are only
two settings: 115V (for 100 – 130V) and 230V (for 220 –
240V). To find the standard voltage level for your
country, visit www.worldstandards.eu/electricity/plug-
voltage-by-country/ .
Install the Spool Holders with the four screws using the 3
mm allen key, ensuring that the longer side is facing up.
Place your PLA on the Spool Holders so that each tip
unwinds upwards through its Filament Guide Tube. Cut
the PLA so the tips are flat, then feed the filament into
the Filament Guide Tube and into the Filament Drive (If
you have trouble feeding filament with a flat tip, then try
cutting it at a 45 degree angle).
1
2
3
To Next Page
Loading...
