6
4
5
Insert the 6 Position Power Supply Connector into the 6
Position Electronics Connector in SECURELY IN PLACE
the electronics case—note that the power supply
connector should run under all other wires. Next, plug the
power supply into a wall outlet and flip the power supply
switch to the on position.
"Download the MakerGear via Quick Start App
www.MakerGear.com/pages/QuickStart-App. Carefully
follow the instructions below to set your starting height
and align your extruders' nozzles.
To use the Quick Start App with your M2e Dual, you must
first elevate your nozzle 2 (right) approximately 2mm
higher than nozzle 1 (left). After tightening the screw to
secure nozzle 2 in its elevated position, simply follow the
instructions provided by Quick Start in order to complete
the "Check Platform" step for Extruder 1.
Loosen the adjacent screw slightly in order to lower
Extruder 2 so that both nozzles are horizontally aligned.
Use your feeler gauge to ensure that Extruder 2 is at the
correct position. After you've placed Extruder 2 in the
correct position, tighten the screw to secure it in place.
7
6
To access the
visit M2 Quick Start App Tutorial,
http://www.makergear.com/pages/quickstart-app
To Next Page
Loading...
