Need help?Do you have a question about the MAKERGEAR M3 and is the answer not in the manual?
General| Layer Resolution | 20 - 300 microns |
|---|---|
| Filament Diameter | 1.75 mm |
| Print Speed | Up to 150 mm/s |
| Frame Material | Aluminum |
| Heated Bed | Yes |
| Nozzle Temperature | Up to 300°C |
| Power Supply | 24V DC |
| Operating Voltage | 110-240V AC |
| Nozzle Diameter | 0.4 mm |
| Connectivity | USB, Ethernet |
| Supported Materials | PLA, ABS, PETG |
Rotate bed hold-down clips to secure glass in place.
Mount spool holder with screws and place spool with filament unwinding upward.
Unpack power supply and set voltage switch (A) to match outlet voltage.
Insert 6-Position Power Supply Connector, connect cord, plug into outlet, and flip switch (B) to ON.
Identifies components visible from the front of the M3 printer.
Identifies components visible from the rear of the M3 printer.
Details the components of the X-stage assembly with diagrams.
To Next Page
