1
Welcome
Your MakerGear M3 3D Printer has arrived!
Do not change your M3’s rmware unless you know exactly
what you’re doing or have been instructed to do so by
MakerGear support.
This booklet can also be found on the MakerGear website at
setup.makergear.com, where you can access additional, more specic
information and resources.
Following minimal setup, your M3 is ready to print out-of-the-box. To ensure
safety as well as high quality printing, carefully follow the Setup instructions
included in this booklet.
This machine was assembled at the MakerGear shop in Beachwood,
Ohio, USA, and was tested for at least six hours to ensure that it was fully
operational at the time of shipping.
Do not remove the lm of yellow polyimide tape from your M3’s
glass bed; this functions as your print surface, and should be
facing up.
To Next Page
Loading...
