Makita 2708 - General Power Tool Safety Rules; General Safety Precautions

Adjustment
1. Split blade adjusting:Make a straight line with Saw. Adjust a gap with outer circle of Saw
2. Angle stopper adjusting:Adjust at 45 and 90 degrees on the basis of Table.
3. Scale arrow adjusting:Loosen the attaching screw for Arrow, and adjust it to the scale.
4. Parallel ruler adjusting:Adjust so that it may be parallel with Saw and beright angle with the rail of Table.
5. Knob 45 adjusting:Adjust it when it does not move up-and-down smoothly orturns by vibration.
Disassembly
[ Separation of Gear housing cover from Motor part w/ Gear Housing ]
(1) Remove Saw blade, Inner flange 55 and Outer flange 55.
(2)Turn Knob 45 left, lower Motor part to the lowest limit, and reverse the mainbody.
(3) Remove Gear housing cover, Blade cover and Screws M5x25.
(4) Gear housing cover and Motor part w/ Gear Housing come apart to both sidesfrom Frame separately.
[ Disassembly of Gear 45 and Spindle]
Remove Retaining ring S20 and Ball bearing 6204LLB from the above mentionedGear housing cover ( 4 ).

[ Disassembly of Armature and Field]
Do it by separating Gear housing ( above mentioned ) from Motor part.

[ Disassembly of Lever 80]
(1) Loosen the fastening Front plate of Lever 80
(2) Put Spanner 17 on Hex. Nut M10-6 ( which is farther from Lever 80), put Hex. rod wrench 6 on Hex. Socket head
bolt . Turn Spanner 17 left and Wrench right, and loosen Nut M10-6.
(3) Then, turn Wrench right , gripping Lever 80, pick out Hex. Socket bolt , andremove Lever 80.
Hex. Nut
Outer flange 55
Saw blade
Inner flange
Pan head
screw M5x25
Blade
covert
Gear housing cover
Table
Gear housing
Motor housing
Frame
Flat washer 40