14.
REMOVE ADJUSTING
KEYS
AND
WRENCHES.
Form habit of checking to
see that keys and adjusting wrenches are removed from tool before turning
it
on.
15.
AVOID UNINTENTIONAL STARTING. Don’t carry tool
with
finger on switch.
Be sure switch is OFF when plugging
in.
16.
EXTENSION CORDS. Make sure your extension cord is
in
good condition.
When using an extension cord, be sure to use one heavy enough to carry
the current your product
will
draw. An undersized cord
will
cause a drop
in
line voltage resulting in loss of power and overheating. Table
1
shows the
correct size to use depending on cord length and nameplate ampere rating.
If
in
doubt, use the next heavier gage. The smaller the gage number, the
heavier the cord.
Ampere
Rating
More
Not
More
Than Than
TABLE
1
MINIMUM
GAGE
FOR
CORD SETS
Total
Length
of
Cord
in
Feet
0
-
25 26
-
50
51
-
100
101
-
150
AWG
0-
6
6
-
10
10
-
12
12
-
16
18 16
14
16
16 14
12
14 12
Not
Recommended
18
16
;:
1
12
17.
OUTDOOR USE EXTENSION CORDS. When tool is used outdoors, use only
extension cords intended for use outdoors and
so
marked.
18.
STAY ALERT. Watch what you are doing, use common sense. Don’t operate
tool when you are tired.
19.
CHECK DAMAGED PARTS. Before further use of the tool, a guard or other
part that is damaged should be carefully checked to determine that
it
will
operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of parts, mounting, and any
other conditions that may affect its operation. A guard or other part that
is damaged should be properly repaired or replaced by an authorized serv-
ice center unless otherwise indicated elsewhere
in
this instruction manual.
Have defective switches replaced by authorized service center. Don’t use
tool if switch does not turn
it
on and off.
20.
GUARD AGAINST ELECTRIC SHOCK. Prevent body contact
with
grounded
surfaces. For example; pipes, radiators, ranges, refrigerator enclosures.
21
.
REPLACEMENT PARTS. When servicing, use only identical replacement parts.
22.
POLARIZED PLUGS. To reduce the risk of electric shock, this equipment has
a polarized plug (one blade is wider than the other). This plug
will
fit in a
polarized outlet only one way. If the plug does not fit fully
in
the outlet,
reverse the
plug.
If
it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
3
To Next Page
Loading...
Need help?
General
