Makita 3612C User Manual

MAINTENANCE
CAUTION :
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down to
the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced
at the
same time. Use
only identical carbon
brushes.
Use
a screwdriver to remove the brush
holder caps. Take out the worn carbon
brushes, insert the new ones and secure the
brush holder caps.
NOTE:
When replacing carbon brush located on
the same side as the knob, remove the
knob first before unscrewing the brush
holder cap.
CAUTION:
Be sure to re-Install the knob after insert-
ing new carbon brush.
Limit mark
Knob Brush holder cap
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed
by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
12

Makita 3612C Specifications

General

Type	Plunge Router
Plunge Capacity	0-60mm
Amperage	15 A
Power Type	Corded
Plunge Depth	0-60mm
Power Input	1850W
Weight	5.5 lbs
Net Weight	5.5 lbs