VOLTAGE WARNING: Before connecting the tool to a power source (receptacle,
outlet, etc.) be sure the voltage supplied is the same as that specified on the
nameplate of the tool. A power source with voltage greater than that specified
for the tool can result in SERIOUS INJURY to the user
-
as well as damage to
the tool.
If
in doubt,
DO
NOT PLUG
IN
THE
TOOL. Using a power source with
voltage less than the nameplate rating is harmful to the motor.
ADDITIONAL SAFETY RULES
1.
Wear hearing protection during extended period of operation.
2.
Handle the bits very carefully.
3.
Check the bit carefully for cracks or damage before operation. Replace
4.
Avoid cutting nails. Inspect for and remove all nails from the workpiece
5.
Hold the tool firmly
with
both hands.
6.
Keep hands away from rotating parts.
7.
Make sure the
bit
is not contacting the workpiece before the switch is turned
8.
Before using the tool on an actual workpiece. let
it
run for
a
while. Watch
9.
Be careful of the bit rotating direction and the feed direction.
cracked or damaged bit immediately.
before operation.
on.
for vibration or wobbling that could indicate improperly installed bit.
IO.
Do
not leave the tool running. Operate the tool only when hand-held.
11. Always switch off and wait for the bit to come to a complete stop before
12.
Do
not touch the bit immediately after operation;
it
may be extremely hot
removing the tool from workpiece.
and could burn your skin.
SAVE THESE INSTRUCTIONS.
4
To Next Page
Loading...
Need help?
General
