Need help?Do you have a question about the Makita 3705 and is the answer not in the manual?
General| Power Source | Electric |
|---|---|
| No Load Speed | 30, 000 RPM |
| Weight | 1.5 kg |
| Voltage | 120V |
| Collet Size | 6 mm |
| Collet Capacity | 1/4 inch |
| Input Power | 370 W |
| Overall Height | 330 mm |
Maintain a clean work area, consider the environment, keep children away, store tools properly, and avoid forcing.
Use correct tools, dress properly, wear safety gear, secure work, maintain balance, and disconnect tools for safety.
Remove keys, avoid unintentional starting, use outdoor cords correctly, and stay alert during operation.
Check for damage, ensure proper repair, guard against shock, use correct parts and voltage for electrical safety.
Wear hearing protection, handle bits carefully, avoid nails, hold tool firmly, keep hands away, check bit contact, and run tool before use.
Observe bit direction, operate only when hand-held, wait for stop, avoid touching hot bits, and protect tool base from chemicals.
Follow procedure to install or remove the trimmer bit, ensuring the tool is off and unplugged.
Learn how to set the desired depth of cut using the clamp bolt and scale label for precise adjustments.
Understand how to start and stop the trimmer using the switch lever for safe and controlled operation.
Learn the correct feed direction for edge cutting and general operation to ensure quality cuts and prevent damage.
Learn how to install and adjust the straight guide for chamfering or grooving straight cuts.
Utilize the trimmer guide for curved cuts in veneers, learning its installation and adjustment for fine finishes.
Employ the templet guide for precise cuts with patterns by passing the bit through a sleeve and sliding along templates.
Learn how to inspect and replace worn carbon brushes to maintain tool performance and safety.
Explore recommended accessories like guides, wrenches, and collet cones for enhanced tool functionality.
Details on Straight Single Flute and Straight 2 Flute bits, including material, part numbers, and dimensions.
Specifications for Carbide Tipped Hinge Mortising bits, with dimensions and part numbers.
Information on Solid Carbide Veining bits, including part numbers and dimensional specifications.
Specifications for Round Nose and Core Box bits, detailing material, part numbers, and dimensions.
Details on Vee Grooving bits (Carbide Tipped) and 14° Dovetail bits (Carbide Tipped) with dimensions.
Specifications for Panel Pilot bits (High Speed Steel) and Corner Rounding bits (High Speed Steel).
Details on Cove bits (High Speed Steel) and Flush Trimmer bits (Solid Carbide) including dimensions.
Specifications for 7° Bevel Trimmer, 2 Flute Flush Trimmer, and Combination Flush/Bevel Trimmer bits.
Details for 3 Flute Flush Trimmer Assembly bits, including material, part numbers, and dimensions.
Specifications for Solid Carbide Flute Flush Replacement Cutters, including part numbers and dimensions.
Information on 1/4" Replacement Arbor and Ball Bearing Pilot, detailing part numbers and dimensions.
Diagram showing all components of the Trimmer Model 3705 with numbered parts for identification.
Detailed list of machine parts with item numbers, descriptions, and quantity used for the Trimmer Model 3705.
Details Makita's one-year limited warranty policy, exclusions, and limitations for product defects.
To Next Page
