Makita DC18RD User Manual

10 ENGLISH
To prevent the switch trigger from being accidentally pulled, a lock-
off lever is provided. To start the tool, depress the lock-off lever
and pull the switch trigger. Tool speed is increased by increasing
pressure on the switch trigger. Release the switch trigger to stop.
21
►1. Switch trigger 2. Lock-off lever
Checking the chain brake
CAUTION: Hold the chain saw with both hands
when switching it on. Hold the rear handle with your
right hand, the front handle with your left. The bar
and the chain must not be in contact with any object.
CAUTION: Should the saw chain not stop
immediately when this test is performed, the
saw may not be used under any circumstances.
Consult our authorized service center.
1. Press the lock-off lever, then pull the switch trig-
ger. The saw chain starts immediately.
2. Push the front hand guard forwards with the back of your hand.
Make sure that the chain saw comes to an immediate standstill.
2 3
1
23
1
► 1. Front hand guard 2. Unlocked position 3. Locked position
Checking the run-down brake
CAUTION: If the saw chain does not stop
within one second in this test, stop using the
chain saw and consult our authorized service
center.
Run the chain saw then release the switch trigger com-
pletely. The saw chain must come to a standstill within
one second.
Adjusting the chain lubrication
Youcanadjusttheoilpumpfeedratewiththeadjusting
screw.Theamountofoilcanbeadjustedusingthe
universal wrench.
1
►1.Adjustingscrew
ASSEMBLY
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION: Do not touch the saw chain with
bare hands. Always wear gloves when handling
the saw chain.
Removing or installing saw chain
CAUTION: The saw chain and the guide bar
are still hot just after the operation. Let them cool
down enough before carrying out any work on
the tool.
To remove the saw chain, perform the following steps:
1. Release the chain brake by pulling the front hand
guard.

Makita DC18RD Specifications

General

Type	Indoor battery charger
Product type	Battery charger
Product color	Black, Blue
Battery voltage	18 V
Battery capacity	- Ah
Charging voltage	14.4 - 18 V
USB port current	1.5 A
Battery technology	-
Recharge indicator	Yes
Brand compatibility	Makita
Battery recharge time	0.37 h
Maximum charging time	0.75 h
Battery capacity (max)	5 Ah
Battery capacity (min)	3 Ah
Power protection features	Over current, Over voltage, Overheating
Number of batteries supported	2
Compatible battery technologies	Lithium-Ion (Li-Ion)
Quantity per pack	1 pc(s)

Weight and Dimensions

Weight	2245 g