To Next PageTo Next PageWhy does my Makita DCS6401 Chainsaw engine not start?
If your Makita Chainsaw engine is not starting or is starting with difficulty, check the following: * Ignition spark. * Fuel tank to ensure it's filled. * Starter to ensure it engages. * Wiring, plug cap, and spark plug for any defects. The issue might be a malfunction in the fuel supply system, compression system, or a mechanical malfunction.
Why is my Makita DCS6401 Chainsaw engine hard to start?
If your Makita Chainsaw engine doesn't start easily, it could stem from issues within the fuel supply, compression, or mechanical components. Check the STOP switch position and inspect for wiring faults, a defective plug cap or spark plug. Ensure the choke is correctly positioned, the carburetor isn't defective, the suction head is clean, and the fuel line is free from bends or interruptions. Also, examine the cylinder base packing ring, radial shaft packings, cylinder or piston rings, and the spark plug seal. Finally, verify the starter spring and internal engine parts are intact.
How to troubleshoot insufficient power in my Makita Chainsaw?
If your Makita Chainsaw lacks power, several factors could be responsible: * A dirty air filter. * Incorrect carburetor adjustment. * A clogged muffler. * A blocked exhaust channel in the cylinder. * A clogged spark arrester screen. Check each of these components to restore optimal performance.
Why is my Makita Chainsaw not lubricating the chain?
If your Makita Chainsaw chain isn't being lubricated, the oil tank might be empty. Also, the oil guide groove might be dirty. Check these two things to ensure proper chain lubrication.
Why is my Makita DCS6401 difficult to start when warm?
If you're having trouble starting your warm Makita Chainsaw, the carburetor adjustment might be incorrect. You should check it.
What to do if the chain on my Makita DCS6401 Chainsaw does not run?
If the chain on your Makita Chainsaw isn't running, it's possible that the chain brake is engaged. Please, check the chain brake.
What to do if my Makita Chainsaw engine starts, but dies immediately?
If your Makita Chainsaw engine starts but immediately shuts down, it could be due to several reasons. Try these: * Adjust the idling. * Clean or replace the fuel filter and carburetor. * Make sure the tank venting is working correctly and the fuel line is intact. * Check the cable and STOP switch.
How to fix warm start difficulties with my Makita DCS6401?
If you're experiencing warm start difficulties with your Makita Chainsaw, the issue might stem from an incorrect carburetor adjustment. To resolve this, adjust the carburetor correctly.
What to do if the chain does not run on my Makita DCS6401 Chainsaw?
If the chain on your Makita Chainsaw isn't running, it's likely because the chain brake is activated. Releasing the chain brake should solve this issue.
What to do if my Makita DCS6401 Chainsaw starts then dies?
If your Makita Chainsaw starts but immediately dies, it could be due to several issues. Check the idling adjustment, and make sure the suction head or carburetor aren't dirty. Also, inspect the tank venting system, fuel line, and cable for defects, and ensure the STOP switch and starting valve are functioning correctly and are clean.
General| Engine Displacement | 64 cc |
|---|---|
| Weight | 6.3 kg |
| Chain Pitch | 3/8" |
| Fuel Capacity | 0.75 L |
| Oil Capacity | 0.42 L |
