Need help?Do you have a question about the Makita DHR263 and is the answer not in the manual?
General| Type | Rotary Hammer |
|---|---|
| Voltage | 18 V |
| Power Source | Battery |
| Chuck Type | SDS-Plus |
| Max. Drilling Capacity (Concrete) | 26 mm |
| Max. Drilling Capacity (Steel) | 13 mm |
| Max. Drilling Capacity (Wood) | 30 mm |
| Battery Type | Lithium-Ion |
| 3 Mode Operation | Yes (Hammering, Hammering with Rotation, Rotation Only) |
| No Load Speed | 0 - 1, 100 rpm |
Lists compatible battery cartridges and chargers for the tool.
Details compatible cord-connected power sources for the tool.
Explains the meaning of various symbols used in the manual and on the tool.
Describes the primary applications and functions of the power tool.
Provides typical A-weighted noise level data for the tool models.
Guidelines for maintaining a safe and accident-free work environment.
Precautions to prevent electric shock and ensure electrical safety.
Essential personal safety measures to protect the operator during use.
Instructions on how to properly use, maintain, and care for the power tool.
Guidelines for servicing the power tool by qualified personnel.
General safety precautions applicable to all operations of the tool.
Precautions to take when using long drill bits to prevent injury.
Advice on how to extend the lifespan and performance of the battery cartridge.
Step-by-step guide for inserting and removing the battery cartridge.
Explains how to check the current charge level of the battery.
How the tool protects itself from excessive current draw.
How the tool protects the battery from overheating.
How the tool protects the battery from deep discharge.
Explanation of how to operate the tool's switch trigger.
Details on how the tool's integrated lamp functions.
How to change the direction of the tool's rotation using the reversing switch.
Instructions for attaching the quick change drill chuck.
Instructions for removing the SDS-plus quick change chuck.
How to select the hammer drilling mode for concrete and masonry.
How to select the rotation-only mode for drilling wood, metal, or plastic.
How to select the hammering-only mode for chipping and demolition.
Instructions for installing and using the auxiliary side grip for better control.
Guidance on applying bit grease for smooth chuck action and longevity.
How to adjust the angle of the bit for chipping or demolition tasks.
Instructions for using the depth gauge to control drilling depth.
Steps for performing hammer drilling operations effectively and safely.
How to use the dust cup accessory for dust prevention during drilling.
Using the blow-out bulb to clear dust from drilled holes.
How to perform chipping, scaling, and demolition tasks with the tool.
Instructions for checking and replacing worn carbon brushes.
To Next Page
