To Next Page
D
Diana WilliamsAug 13, 2025
What to do if the switch is broken on my Makita Impact Driver?
- CCameron ReynoldsAug 13, 2025
If the switch of your Makita Impact Driver is broken, you should replace it.
What to do if the switch is broken on my Makita Impact Driver?
If the switch of your Makita Impact Driver is broken, you should replace it.
What to do if the rotor is broken on my Makita DTD170?
If the rotor of your Makita Impact Driver is broken, you should replace it.
What to do if the stator is broken on my Makita DTD170?
If the stator of your Makita Impact Driver is broken, you should replace it.
What to do if the controller is broken on my Makita DTD170?
If the controller of your Makita Impact Driver is broken, you should replace it.
What to do if the LED circuit is broken on my Makita DTD170?
If the LED circuit of your Makita Impact Driver is broken, you should replace it.
What to do if lead wires are broken on my Makita DTD170?
If the lead wires of your Makita Impact Driver are broken, you should replace them.
What to do if the terminal is broken on my Makita DTD170 Impact Driver?
If the terminal of your Makita Impact Driver is broken, you should check the terminal or replace it.
What to do if connectors are in incomplete connection on my Makita DTD170?
If connectors are in incomplete connection of your Makita Impact Driver, you should check the lead wires, or replace them.
General safety rules for operating power tools.
Specific safety precautions for cordless impact drivers.
Crucial safety guidelines for handling the battery cartridge.
Tool stops automatically when battery capacity is insufficient.
Displays the remaining battery charge level via indicator lamps.
Tool automatically stops if it draws abnormally high current.
Instructions for turning on and off the front lamp.
How to change the direction of rotation of the tool.
Description of the easy-to-use mode for controlled screw driving.
Procedure for installing and removing driver bits and socket bits.
Guidance on how to install the convenient tool hanging hook.
General| Voltage | 18V |
|---|---|
| Max Torque | 170 Nm |
| No Load Speed | 0 - 3, 600 RPM |
| Impact Rate | 0 - 3, 800 ipm |
| Chuck Size | 1/4" Hex |
| Battery Type | Lithium-ion |
| Type | Impact Driver |
