To Next PageTo Next PageWhy is Torque Boost not available on my Makita DUA300ZB?
The Torque Boost mode on your Makita Pole Saw might not be available immediately after replacing the battery. Depending on how you use the tool, the Torque Boost mode may not be available right away. Try using the tool in normal mode until the installed battery is empty, then replace or recharge the battery.
What to do if Makita DUA300ZB has abnormal vibration?
If your Makita Pole Saw is vibrating abnormally, stop using it immediately. Check if the guide bar or saw chain is loose and adjust the tension accordingly.
What does blinking green light mean on Makita DUA300ZB?
If the main power lamp on your Makita Pole Saw is blinking green, it means the switch trigger is being pulled before the main power switch is turned on. Make sure to turn on the main power switch before pulling the switch trigger.
Why Makita Pole Saw doesn't reach maximum RPM?
If your Makita Pole Saw isn't reaching its maximum RPM, the possible reasons are: * The battery cartridge may not be installed correctly. Ensure it is installed as described in the manual. * The battery power might be dropping. Try recharging or replacing the battery cartridge.
What to do if my Makita DUA300ZB chain has no oil?
If there's no oil on the chain of your Makita Pole Saw, try these steps: 1. Check the oil tank and fill it if it's empty. 2. Inspect the oil guide groove and clean it if it's dirty. 3. Adjust the oil delivery amount using the adjusting screw to ensure proper lubrication.
Why does my Makita Pole Saw motor stop quickly?
If the motor of your Makita Pole Saw stops running after a short period, it's likely due to a low battery charge. Try recharging the battery. If the issue persists after recharging, consider replacing the battery cartridge.
What to do if Makita Pole Saw does not start?
If your Makita Pole Saw doesn't start, here are a few things to check: * Make sure the battery cartridge is properly installed and charged. If it's not installed, install a charged one. If the battery is low, recharge it, or replace it if recharging doesn't help. * Ensure the main power switch is turned on. The tool automatically turns off after a period of inactivity, so you may need to turn it back on.
General| Type | Pole Saw |
|---|---|
| Battery Voltage | 18V |
| Tool Type | Cordless |
| Chain Gauge | 1.1 mm |
| Power Source | Battery |
| Bar Length | 300 mm |
| Chain Pitch | 3/8" |
