What to do if the saw chain does not move on my Makita Trimmer?
If the saw chain on your Makita Trimmer isn't moving, the guide bar might be bent or damaged, requiring replacement. Alternatively, a twig could be caught in the saw chain, so remove any foreign matter. If these aren't the issue, the drive system may not be working correctly.
What to do if my Makita Trimmer chain oil is not supplied?
If chain oil is not being supplied, there are several potential causes. First, check if the oil tank is empty and fill it with chain oil if needed. If the tank isn't empty, the chain-oil feed port may be dirty; clean the chain-oil feed port on both the unit and the guide bar. Finally, ensure that the adjusting screw of the chain-oil feed rate is properly set.
Why is my Makita Pole Saw not supplying chain oil?
If chain oil is not being supplied by your Makita Pole Saw, there are several possible reasons. First, the oil tank might be empty, so you should fill it with chain oil. Second, the chain-oil feed port could be dirty; clean the chain-oil feed port on both the unit and the guide bar. Finally, the adjusting screw of the chain-oil feed rate may be improperly set, so ensure that it is correctly adjusted.
What to do if the saw chain on my Makita EY401MP doesn't move?
If the saw chain on your Makita Pole Saw isn't moving, it could be due to several reasons. The guide bar may be bent or damaged, in which case you should replace it. Alternatively, a twig might be caught by the saw chain, so remove any foreign matter. If these steps don't resolve the issue, the drive system may not be working properly, and you should ask Makita authorized service center to inspect and repair it.
Why is my Makita EY401MP Pole Saw vibrating abnormally?
If your Makita Pole Saw is vibrating abnormally, the drive system may not be working properly. Ask Makita authorized service center to inspect and repair it.
What to do if the saw chain on my Makita EY401MP Pole Saw does not move?
If the saw chain on your Makita Pole Saw isn't moving, it could be due to a few reasons. First, the guide bar might be bent or damaged, requiring replacement. Second, a twig might be caught in the saw chain, which you should remove. Lastly, if the drive system isn't working properly, it should be inspected and repaired by a Makita authorized service center.
Symbol indicating special care and attention is required.
Symbol for mandatory personal protective equipment.
Safety symbol for maintaining a safe distance from hazards.
Operational angle limit for pole saw safety.
Requirements for protective gear during operation.
Safety considerations for the operating environment.
General| Power source | Battery |
|---|---|
| Battery Type | Lithium-Ion |
| Type | Pole Saw |
| Bar Length | 10 inches |
| Chain Gauge | 0.043" |
To Next Page
