Why is there no oil on my Makita DUA301PT2 Pole Saw chain?
If there's no oil on the chain of your Makita Pole Saw, several reasons are possible. The oil tank might be empty, so refill it. The oil guide groove could be dirty, requiring cleaning. Also, the oil delivery might be poor; in this case, adjust the amount of oil delivery using the adjusting screw.
How to fix a Makita Pole Saw that won't start?
If your Makita Pole Saw isn't starting, several factors could be at play. First, ensure a charged battery cartridge is correctly installed. If the battery is low, recharge it or replace it if recharging doesn't help. Also, verify that the main power switch is turned on.
What to do if my Makita DUA301PT2 Pole Saw motor stops quickly?
If the motor of your Makita Pole Saw stops running after only a short time, the battery's charge level is likely low. Recharge the battery. If the issue persists after recharging, consider replacing the battery.
Why my Makita DUA301PT2 Pole Saw does not reach maximum RPM?
If your Makita Pole Saw isn't reaching its maximum RPM, there are a few potential causes. Ensure the battery cartridge is properly installed as described in the manual. If the battery power is dropping, recharge or replace the battery cartridge. If these steps don't resolve the issue, it may be related to the drive system.
What to do if Makita DUA301PT2 has abnormal vibration?
If your Makita Pole Saw exhibits abnormal vibration, stop using it immediately. This could be due to a loose guide bar or saw chain, which requires tension adjustment.
Why is the main power lamp blinking green on my Makita DUA301PT2?
If the main power lamp on your Makita Pole Saw is blinking green, it means the switch trigger is being pulled before the main power switch is turned on. To resolve this, first turn on the main power switch, and then pull the switch trigger.
Why isn't Torque Boost available on my Makita Pole Saw after a battery change?
The Torque Boost mode on your Makita Pole Saw may not be immediately available after replacing the battery, depending on usage conditions. You can use the tool in normal mode until the installed battery is empty, then replace it with a fully charged one, or recharge the battery.
What to do if Makita Pole Saw does not start?
If your Makita Pole Saw doesn't start, here are a few things to check: * Make sure the battery cartridge is properly installed and charged. If it's not installed, install a charged one. If the battery is low, recharge it, or replace it if recharging doesn't help. * Ensure the main power switch is turned on. The tool automatically turns off after a period of inactivity, so you may need to turn it back on.
Why does my Makita DUA301PT2 Pole Saw motor stop quickly?
If the motor of your Makita Pole Saw stops running after a short period, it's likely due to a low battery charge. Try recharging the battery. If the issue persists after recharging, consider replacing the battery cartridge.
What to do if my Makita DUA301PT2 Pole Saw chain has no oil?
If there's no oil on the chain of your Makita Pole Saw, try these steps: 1. Check the oil tank and fill it if it's empty. 2. Inspect the oil guide groove and clean it if it's dirty. 3. Adjust the oil delivery amount using the adjusting screw to ensure proper lubrication.
General| Type | Pole Saw |
|---|---|
| Power Source | Battery |
| Battery Voltage | 18V |
| Battery Capacity | 5.0Ah |
| Blade Length | 30 cm |
| Oil Tank Capacity | 120 ml |
| Chain Pitch | 3/8" |
| Bar Length | 30 cm |
| No Load Speed | 6.5m/s |
To Next Page
