Why Makita DUA301 Pole Saw doesn't reach maximum RPM?
If your Makita Pole Saw isn't reaching its maximum RPM, the possible reasons are: * The battery cartridge may not be installed correctly. Ensure it is installed as described in the manual. * The battery power might be dropping. Try recharging or replacing the battery cartridge.
What does blinking green light mean on Makita Pole Saw?
If the main power lamp on your Makita Pole Saw is blinking green, it means the switch trigger is being pulled before the main power switch is turned on. Make sure to turn on the main power switch before pulling the switch trigger.
Why is Torque Boost not available on my Makita DUA301 Pole Saw?
The Torque Boost mode on your Makita Pole Saw might not be available immediately after replacing the battery. Depending on how you use the tool, the Torque Boost mode may not be available right away. Try using the tool in normal mode until the installed battery is empty, then replace or recharge the battery.
General| Type | Pole Saw |
|---|---|
| Power Source | Battery |
| Bar Length | 8 inches |
| Weight | 7.3 lbs (without battery) |
| Voltage | 18V |
| Oil Tank Capacity | 160 ml |
| Chain Gauge | 0.043" |
| Chain Pitch | 1/4 inches |
| No Load Speed | 1, 500 FPM |
| Maximum Cutting Length | 30 cm |
| Blade Length | 8 inches |
To Next Page
