To Next PageTo Next PageWhy is the main power lamp blinking green on my Makita DUC254CZ?
If the main power lamp on your Makita Chainsaw is blinking green, it means that the switch trigger is being pulled under an inoperable condition. Pull the switch trigger after the main power switch is turned on and the chain brake is released.
Why does my Makita DUC254CZ not start?
Your Makita Chainsaw might not be starting due to several reasons: the battery cartridge may not be installed—install a charged battery cartridge. There could be a battery problem, such as low voltage—recharge the battery cartridges, or replace them if recharging isn't effective. Alternatively, the main power switch might be off—turn the main power switch on.
How to troubleshoot a Makita DUC254CZ Chainsaw that does not start?
If your Makita Chainsaw does not start, a possible cause is that the battery cartridge is not installed. To fix this, install a charged battery cartridge. Another reason could be a battery problem such as low voltage. In this case, try recharging the battery cartridges; if that doesn't work, replace the battery cartridge. Also, the main power switch might be off. If so, turn the main power switch on again, as the chainsaw automatically turns off if left unused for a while.
Why doesn't my Makita Cordless Saw reach maximum RPM?
If your Makita Cordless Saw isn't reaching maximum RPM, it could be due to a few reasons: the battery cartridge might be installed improperly (install the battery cartridges correctly), or the battery power may be dropping (recharge or replace the battery cartridge). If these steps don't resolve the issue, ask the authorized service center in your region for repair.
Why is the Torque Boost mode not available on my Makita Chainsaw?
If the Torque Boost mode is not available on your Makita Chainsaw after replacing the battery cartridge, use the tool in the normal mode until the installed battery cartridge becomes empty, and then replace the battery cartridge with a fully charged one, or recharge the battery cartridge.
Why is my Makita DUC254CZ vibrating abnormally?
If you experience abnormal vibration with your Makita Chainsaw, stop the machine immediately! This could be due to a loose guide bar or saw chain. Adjust the guide bar and saw chain tension. If the issue persists, it may indicate a tool malfunction, and you should ask the authorized service center in your region for repair.
What to do if my Makita Cordless Saw chain is not running?
If the saw chain on your Makita Cordless Saw isn't running, it's likely that the chain brake is activated. Release the chain brake to allow the chain to run.
How to troubleshoot a Makita Cordless Saw that won't start?
If your Makita Cordless Saw doesn't start, here are a few things to check: * Ensure a charged battery cartridge is correctly installed. * Recharge the battery. If it remains ineffective, consider replacing the battery cartridge. * If the main power switch is off (the chainsaw automatically turns off after a period of inactivity), turn it on again.
What should I do if my Makita Cordless Saw has abnormal vibration?
If you experience abnormal vibration with your Makita Cordless Saw, stop the machine immediately and adjust the guide bar and saw chain tension if they are loose.
What to do if my Makita DUC254CZ Chainsaw motor stops after a little use?
If the motor of your Makita Chainsaw stops running after a short period, it's likely due to a low battery charge. Recharge the battery. If the issue persists after recharging, consider replacing the battery cartridge.
General
