Why does the motor not run on my Makita DUR142L?
If your Makita Trimmer's motor doesn't run, it could be due to several reasons. First, make sure the battery cartridge is properly installed. If it is, the battery might be low or faulty; try recharging it or replacing it if recharging doesn't work. If these steps don't resolve the issue, the drive system may have a problem, requiring repair by an authorized service center.
What to do if the cutting tool does not rotate on my Makita Trimmer?
If the cutting tool on your Makita Trimmer isn't rotating, stop the machine immediately. Check for any foreign objects, like a branch, that might be jammed between the guard and the nylon cutting head, and remove them. If there are no obstructions, the drive system may not be working correctly, and you should seek repair from an authorized service center.
Why does my Makita DUR142L motor stop running after a little use?
If your Makita Trimmer stops running after a short period, there are a few potential causes. Check the direction of rotation and change it with the reversing switch if necessary. Also, the battery's charge level might be low, so try recharging it or replacing it if recharging isn't effective. Overheating can also cause this issue; if so, stop using the tool and allow it to cool down.
Why won't my Makita DUR142L motor run?
The motor of your Makita Trimmer might not be running because the battery cartridge isn't installed properly, so install the battery cartridge. Another reason could be a battery problem, such as undervoltage, in which case you should recharge the battery, and if that doesn't work, replace it.
What to do if Makita Trimmer motor stops after short use?
If your Makita Trimmer's motor stops running after a short period, it could be due to the rotation being in reverse. Change the direction of rotation with the reversing switch. Alternatively, the battery's charge level might be low, so recharge the battery; if that doesn't help, replace the battery. Overheating can also cause this issue; stop using the tool to allow it to cool down.
Why is my Makita DUR142L Trimmer not reaching maximum RPM?
Your Makita Trimmer might not be reaching maximum RPM because the battery is installed improperly; install the battery cartridge as described in this manual. Another cause could be dropping battery power, so recharge the battery, and if recharging isn't effective, replace the battery.
What to do if the cutting tool of my Makita DUR142L Trimmer does not rotate?
If the cutting tool on your Makita Trimmer isn't rotating, a foreign object, like a branch, might be jammed between the guard and the nylon cutting head. Remove the foreign object.
How to fix abnormal vibration in Makita DUR142L Trimmer?
If your Makita Trimmer is vibrating abnormally, it could be because one end of the nylon cord has broken. Bump the nylon cutting head against the ground while it is rotating to cause the cord to feed.
What to do if the cutting tool and motor of my Makita Trimmer cannot stop?
If the cutting tool and motor of your Makita Trimmer won't stop, remove the battery.
What to do if the cutting tool and motor cannot stop on my Makita Trimmer?
If the cutting tool and motor on your Makita Trimmer won't stop, immediately remove the battery. This indicates an electric or electronic malfunction that requires repair by an authorized service center.
Details sound pressure level and uncertainty.
Details measured vibration emission values.
General| Motor Type | Brushless |
|---|---|
| Battery Voltage | 18V |
| Vibration Level | 2.5 m/s² |
| Power Source | Battery |
| Battery Type | Li-ion |
| Noise Level | 87 dB(A) |
| No Load Speed | 6, 000 rpm |
To Next Page
